The LM40-PC Load Cell Monitor provides a digital readout at floor level of the weight of hanging loads. This enables you to see at a glance the weight on each point without the inconvenience of the conventional dynamometer method. The 40 load cells included with the LM40-PC are fitted with fully digital electronics, sensor cabling, monitoring software, and display terminal. This can be expanded to any number or used for a single point. Each load cell is rated at 6,000 Ibs. capacity and is calibrated to +/-1 %. Unlike analog based cells, our digital load cells eliminate the need to recalibrate to compensate for varying cable lengths. The monitoring software provides individual point load, total of all points, peak hold, and parameters for setting over limit and under limit alarms. Other features include weight history, statistical processing such as averaging and graphing, and printer output.
Standard Features: *40 channel monitor runs on 110/220V, at 2 amps *Uses same breakout boxes and multi-cables as Computerized Hoist *Control Fully digital interface between loadcell and monitor *Load cell capacity of 6,000 Ibs. standard, with alarm higher capacities available * Load cell accuracy range +/? 1 % Rugged load cell construction * Optional: Serial or network connection to external computer	Software features: * Standard readout capacity 1?40 points, expandable to any number * Total weight of all points * Individual point readout * Peak hold readout: High, low & total * Capability to set over/under limits * Printer output available * Storage to disk